Operating instructions
42 Stopping the engine
Stopping the engine
1 If possible park the excavator on a solid, level base and lower
the working attachment to the ground.
2 Reduce the engine speed: Set the throttle lever to "idle speed
position".
NOTE! Do not shut the engine down all of a sudden from full
load, but let it idle for a short while for temperature equaliza-
tion.
1 To shut the engine down turn the ignition key in the ignition
switch to "Stop position" (position 1)!
2 All control lights go out.
3 Check whether all switches and control elements are switched
off or out of function.
4 Pull the ignition key out of the ignition switch when it is in "Stop
position" (position 1).
5 Position console (4) in position (A) for interlocking. The opera-
ting levers for working and travel hydraulics are locked (no mo-
vement possible).
6 Interrupt the electric supply with the battery disconnecting
switch (option).
Please consider that the risk of theft or burglary can be minimized
by applying the following precautions:
– Remove the key from the ignition switch if the machine is unat-
tended.
– Close doors, hoods and covers after work.
– Interrupt the electric power supply with the battery disconnec-
ting switch (option) and remove the handle of the battery dis-
connecting switch (option).
– Park the machine at a place where the risk of theft or burglary
is only minimal.
– Remove all valuables from the cab.
– Fasten the machine with a chain.
WARNING!
Before leaving the cab lower the excavating attachment to
the ground. Pull the safety locking lever back to lock the
control functions.
1
2
3
1012124
A
B
4
To Next Page
Loading...
