172
ECS Gen. 2
Load height - M1
Pressing the function switch changes the chassis height to
that stored as M1.
Can be applied when the road speed is < 30 kmh, and
functions 1, 2, 3, or 6 are not active or requested.
Note: The truck must have a remote control which allows
load height M1 to be set for a full air suspension system.
Function 5 on its own - DIH on pin X2-06 (BHA-5)
Function 5 + another function - DIH on pin X2-66 (BHB)
One x 2 position switch - (BHB)
Two x 2 position switch - (BHA-5)
Function 5
Programming
To Next Page
