135
ECS Gen. 2
Solenoid valve
block - drive
axle - 4x2 -
suspension lower
If the driver presses the bogie switch to ʻlowerʼ position,
and/or the ECU receives a ʻlowerʼ signal from a height
sensor, the ECU sends +24 V to energise the drive axle
solenoid.
The control solenoid is not energised, so a path from the
drive axle solenoid valve to exhaust, via the control valve,
is created.
The chassis is lowered to the required height.
To Next Page
Loading...
