29
General information
Height sensors
- number
The number of sensors varies according to truck model and
axle configuration.
All air suspended trucks have two rear sensors - except -
4x2 tractor with front leaf springs (RAD-A4), which has only
one sensor at the O/S.
Note: The use of only one sensor is possible because a
4x2 tractor has a short wheelbase. This means that the
chassis frame is rigid, with very little twist. Consequently,
there is little side to side height deviation.
Trucks with front air suspension (FSS-AIR) have one front
sensor.
The chart above shows the unique reference numbers for
each sensor.
Note: If a sensor is removed and refitted, or renewed, it
must be calibrated using VCADSPro.
Calibration
To Next Page
Loading...
