178
ECS Gen. 2
Additional
functions - wiring
connection
The additional functions are hard wired into connector (FA),
pins (2) and (3), and can be activated by either:
- a DIH signal to pin (06) plug (X2) from an additional
switch.
- a DIH signal to pin (16) plug (X2) from an additional
switch.
Depending upon the requirements of the customer,
activation be arranged as follows:
1 or 2 functions activated by one x 2 position switch, or one
x 3 position switch.
2 functions activated by two x 2 position switches.
For more information, refer to IMPACT section (72).
Switch
permutations
To Next Page
