81
ECS Gen. 1
Changing the
drive height
CAUTION
To avoid possible vibration and excessive prop-shaft
angles, which may cause instability or component damage,
the drive height must not be changed by more than the
values in the chart above.
The system will allow the drive height to be changed up to
+/- 40 mm.
However, as shown in the chart, the maximum permissible
height increase is +10 mm - and this is only with bogie
arrangement RADT-A6, with chassis height CHH-STD.
DANGER: Do not leave the control switch in the “MAN 1”
position when working on the truck, with the ignition off.
Because the system is in stand-by mode, automatic height
adjustment may still occur.
This may cause a dangerous situation if chassis height
suddenly and unexpectedly changes.
To Next Page
Loading...
