Volvo STD 101-0001 - User Manual

Standard STD 101-0001
Volvo Group
Established
December 2007
Version
4
Page
1(36)
The English language version is the original and the reference in case of dispute.
BASIC RULES FOR REPRESENTATION
Digital product-definition data practices
Orientation
This standard is based on the international standard ISO 16792:2006 and the American standard
ASME 14.41-2003.
The technical content of section 3, dealing with the combination of drawing and Digital Shape Model
(DSM), corresponds to version 3 of this standard.
This version differs from version 3 in that the title of the standard has been changed from Digital Shape Model
basis – DSM basis to Digital product-definition data practices, which is equal to the title of ISO 16792. In order to
bring the standard in line with ISO 16792, the contents have been completely re-worked and sections 2 Terms
and definitions, 4 Model-only and 5 Reference to this standard on model have been added.
Contents
1 Scope and field of application
2 Terms and definitions
3 Drawing and Digital Shape Model (DSM) in combination
3.1 Reference on drawing
4 Model-only
4.1 General model requirements
4.2 Digital Shape Model (DSM) requirements
4.3 Common requirements for product-definition data
4.4 General notes and local notes
4.5 Model values and dimensions
4.6 Datum applications
4.7 Geometrical tolerances
4.8 Surface texture
4.9 Other applications of 3-D annotation
5 References to this standard on model
1 Scope and field of application
This standard specifies requirements for the preparation and presentation of digital product-definition data,
hereafter referred to as data sets. It supports two methods of application: model-only, and model and drawing in
digital format.
Some parts of the standard are primarily intended as guidelines for IT engineers, but may also be
of general interest. These parts have been marked with the following symbol in the right-hand
margin of the standard.
The rules are intended for use within all Business units and Business areas of the Volvo Group. However, before
starting using model-only (annotated models), the method shall be approved for use within each organization in
question. For approval, this check list shall be used:
• Are all necessary functionalities implemented in the concerned CAD systems?
• Is there a clear business case (e.g. shorter lead-times, increased quality)?
• Are all down-stream systems and work processes aligned (purchasing, manufacturing, aftermarket, etc.)?

Summary

Scope and Field of Application

Terms and Definitions

Drawing and Digital Shape Model (DSM) in Combination

Reference on Drawing

Specifies text note requirements when a drawing is used with a digital shape model (DSM).

Model-Only

General Model Requirements

Requirements for the data set to provide complete product definition, including DSM, annotation, and documentation.

Fundamental Principles

Fundamental requirements for annotated models, including the ability to query the model.

Digital Shape Model (DSM) Requirements

Specifies requirements for digital shape models, including geometric form and dimensional condition.

Common Requirements for Product-Definition Data

Establishes common requirements for application, display management, and query of product definition data.

Model Values and Dimensions

Requirements for model-value query, resolved dimensions, and their association to geometry.

Datum Applications

Practices for organizing, attaching, and displaying datum indicators and related information associative with models.

Geometrical Tolerances

Rules for connecting tolerance frames to toleranced features in a 3-D environment.

References to This Standard on Model

Volvo STD 101-0001 Specifications

General

Brand	Volvo
Model	STD 101-0001
Category	Automobile
Language	English