Standard STD 101-0001
Volvo Group
Version
4
Page
4
Figure 2 gives an example of an orthographic drawing depicting the modelled part and figure 3 shows an
axonometric drawing stating the same requirements. Irrespective of the method used to depict the part,
orthographic or axonometric, the drawing shall contain a note stating that DSM is basis for dimensions not stated
on the drawing, and also give reference to this standard. See also section 3.1.
20
40
40
40
22
A
B
C
A
A
1234567X
Ø1 M
A B C
4xØ15±0,5
0,8 B
0,8
UNLESS OTHERWISE STATED
DIGITAL SHAPE MODEL
IS BASIS WHERE DIMENSIONS ARE OMITTED
STD 101-0001
SYMBOLS, DESIGNATIONS AND GENERAL DRAWING
METHODS STD 101-0005
A B C
2
Figure 2 – Orthographic engineering drawing to be used along with the DSM
To Next Page
Loading...
