10
DIGITAL MUSIC CORPORATION
After entering Setup mode, activate this function by pressing
[DEVICE NAME/MIDI CHANNEL]. The display will read:
1. DEVICE / 01
↑ ↑ ↑
Number Name Channel
Number
You can define devices 1-8. This number tells you which
device you are defining. Press [SELECT ∧ or ∨] to choose the
number of each device.
Name
You should enter the actual name of your devices, such as
"MPX-1", "EVENTIDE" or "TRIAXIS".
The Ground Control starts with device #1 named "DEVICE".
Devices 2-8 are blank. You change the name using the
[DATA] and [CURSOR] buttons.
Note: If you press and hold a button it will repeat. You can press
both [DATA] buttons at the same time for a space.
Channel
Each of your devices must be set to respond to a particular
MIDI channel, 1-16. The channel must match the number you
enter here.
Each of the devices (1-8) which are not being used must be set
to "--". This turns off the device.
To set the channel:
1. Press [CURSOR >] until the channel is blinking.
2. Press [DATA +/-] to select the desired channel number or
"--" for off.
To Next Page
Loading...
