19
DIGITAL MUSIC CORPORATION
PROGRAM DEVICES
This is where you will:
• Select the Program for each MIDI controlled device.
• Specify what each Expression Pedal will control.
• Set the System Mix Plus volume.
• Setup audio loops and switches on the GCX(s).
• Name and save each combination as a Preset.
The changes occur in "real time" while you edit your presets,
so you can experiment with new tone combinations before you
save them.
Entering PROGRAM DEVICES
¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯
When you power up the Ground Control, it starts out in Preset
mode. After displaying a startup message (which you can skip
by pressing any button), a directory of the presets in bank #0
will begin to scroll.
Before you enter Program Devices mode, you should select the
preset you want to edit. You can do this by pressing any button
[0-9]. The display will show that preset, for example:
01. INIT
Now to edit preset 01, you will press and hold [SELECT ∨]
until the Program Devices light (in the upper right) comes on.
If you were in a bank other than 0, you would press and hold
[SELECT ∨] until you reach bank 0. Then press and hold a
second time until the Program Devices light comes on.
Note: The delay in entering Program Devices is so that you don't
accidentally enter this mode during performance.
To Next Page
Loading...
Need help?
General
