21
DIGITAL MUSIC CORPORATION
• If the device starts at 0, then choose program 128 by
pressing [1] [2] [8].
When no program is selected, the display will show "--"
instead of a program number.
Using Expression Pedals
¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯
Before using Expression Pedals, you need to enable and
calibrate them from Setup mode.
You specify what each Expression Pedal will control by
pressing [SELECT ∨] until the following display appears with
the desired pedal number:
P1. 064 CTL007
↑ ↑ ↑
Pedal Current Message Type
Value
Message Type
Now you need to choose a MIDI message type. It doesn't
matter which you choose as long as it matches the message
type that your device is set to respond to. The choices are:
• No output: "OFF"
• Pitch Bend: "PITCHB"
• Aftertouch: "AFTERT"
• Continuous Controllers 000 through 120: "CTL007"
To choose the MIDI message type press (or press and hold)
[DATA].
Target Device
To Next Page
Loading...
Need help?
General
