13
DIGITAL MUSIC CORPORATION
Expanders
¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯
Expanders allows you to configure your Ground Control for
use with the following:
• GCX Guitar Audio Switcher(s)
• Ground Link
• System Mix Plus
GCX Guitar Audio Switcher
The Ground Control can control up to 4 GCXs to provide any
combination of 32 audio loops and switches. To control GCXs
from your Ground Control, they must be enabled here.
After entering Setup mode, activate this function by pressing
[EXPANDERS]. The display should read:
GCX-1 IS OFF
To enable the GCX, press [+/YES] to turn GCX #1 on. If you
have more than one GCX, press [SELECT ∨] to access the next
GCX. The display will show:
GCX-2 IS OFF
You can continue to enable GCXs #2 through #4.
For most applications, you will use loops as either audio loops
or latching switches. If you need to control a momentary
switch function with one of the GCX loops, you must
configure it as follows:
1. Press [SELECT ∧ or ∨] to select the appropriate GCX.
2. Press [CURSOR >] to access the desired loop. The display
will look like:
LOOP4=NORMAL
3. Press [+/YES] to select "MOM SW" for momentary switch
operation. Press [-/NO] to return to normal.
To Next Page
Loading...
Need help?
General
