14
DIGITAL MUSIC CORPORATION
Ground Link
Normal operation of the Ground Link is to control loops 1-8 of
GCX #1. You can redefine each button on the Ground Link to
control one of the following:
• Any loop of the GCX(s).
• Start and Stop a MIDI sequencer.
• Send MIDI continuous controller on/off messages.
To redefine Ground Link buttons, enter Setup mode and
activate this function by pressing [EXPANDERS]. Then press
[SELECT ∨] until you see:
G.LINK=NORMAL
Press [+/YES] and [-/NO] to toggle between Normal and
Programmed ("PROGRM") mode.
Once you have selected programmed mode, you can specify
button function by pressing [CURSOR >] to access the display
for each button. The first digit always indicates which button
you are programming.
GCX Loops:
The basic display reads:
3.GCX-1 LOOP6
This indicates that Ground Link button #3 will control loop 6
on GCX #1. Use [CURSOR < or >] to move the cursor and
select each parameter (Ground Link button #, GCX # or Loop
#). Then use [-/NO] and [+/YES] to alter them.
MIDI Sequencer Start/Stop:
With the cursor on the GCX #, such as:
3.GCX-1
LOOP6
To Next Page
Loading...
