Voom SuperDuper - Remove DCO Procedure

Voom Technologies, Inc. © 2007-2013 Proprietary www.voomtech.com
6.7 Remove DCO Procedure
The following table describes the sequence associated with removing a DCO
from each of the target drives using the button panel interface.
LCD interface Comments
SuperDuper 2-01
Status: Ready
Drives: 12345678
From the main window, press <menu> to
display the initial menu item.
1:System Test
Press < menu > again to advance to the next
menu item.
2:Clone Drive
Press < menu > again to advance to the next
menu item.
3:Verify Drives
Press < menu > again to advance to the next
menu item.
4:Wipe Drives
Press < menu > again to advance to the next
menu item.
5:Remove HPA
Press < menu > again to advance to the next
menu item.
6:Remove DCO
Press <enter> to execute the remove DCO
command.
Remove Target DCO
OK (enter/cancel)?
Press <enter> to acknowledge that you want to
proceed.
Removing Target 1
DCO
Interim status of the remove DCO operation.
. . .
Removing Target 8
DCO
Interim status of the remove DCO operation.
Operation Complete
The status displayed after it completes the
command.
16