Voom SuperDuper - Remove DCO Procedure

Voom Technologies, Inc. © 2007-2013 Proprietary www.voomtech.com
7.6 Remove DCO Procedure
When using the serial interface, the command syntax for removing a DCO from
each of the target drives is given below:
DCO
=> DCO
Remove Target DCO
OK (y/n)? y
Removing DCO from Target drive 1
Removing DCO from Target drive 2
Removing DCO from Target drive 3
Removing DCO from Target drive 4
Removing DCO from Target drive 5
Removing DCO from Target drive 6
Removing DCO from Target drive 7
Removing DCO from Target drive 8
Operation Complete
21