Voom SuperDuper - System Test Procedure; Clone Drive Procedure

Voom Technologies, Inc. © 2007-2013 Proprietary www.voomtech.com
7.1 System Test Procedure
When using the serial interface, the command syntax for testing the system
configuration is given below:
Test
=> Test
Test System Drives
OK (y/n)? y
Reading 32 sectors from Source drive
Reading 32 sectors from Target drive 1
Reading 32 sectors from Target drive 2
Reading 32 sectors from Target drive 3
Reading 32 sectors from Target drive 4
Reading 32 sectors from Target drive 5
Reading 32 sectors from Target drive 6
Reading 32 sectors from Target drive 7
Reading 32 sectors from Target drive 8
Operation Complete
7.2 Clone Drive Procedure
When using the serial interface, the command syntax for testing the system
configuration is given below:
Clone [-vn] [blks]
-n (n)o-wipe, disable the auto-wipe
-v (v)erify, re-verify destination
blks only clone blks sectors to destination
=> Clone
Clone Source Drive
OK (y/n)? y
Copying 78165360 sectors from Source drive to Target drives
00:00:10, 999936 sectors, 58.2MB/sec (3.0GB/min average)
00:00:20, 2161152 sectors, 58.2MB/sec (3.2GB/min average)
00:00:30, 3322368 sectors, 58.2MB/sec (3.3GB/min average)
. . .
00:14:33, 78165360 sectors, 43.6MB/sec (2.7GB/min average)
Clone Complete (00:14:33, 40.0GB)
Wiping 78136128 sectors from Target drive
00:00:10, 1128960 sectors, 56.8MB/sec (3.3GB/min average)
00:00:20, 2290176 sectors, 56.8MB/sec (3.3GB/min average)
00:00:31, 3451392 sectors, 56.8MB/sec (3.3GB/min average)
18