Voom Technologies, Inc. © 2007-2013 Proprietary www.voomtech.com
7.4 Wipe Drives Procedure
When using the serial interface, the command syntax for wiping each of the
target drives is given below:
Wipe [blks]
blks only wipe blks sectors
=> Wipe
Wipe Target Drives
OK (y/n)? y
Wiping 156301488 sectors on Target drives
00:00:10, 1161216 sectors, 67.7MB/sec (3.4GB/min average)
00:00:20, 2515968 sectors, 67.8MB/sec (3.7GB/min average)
00:00:30, 3870720 sectors, 67.8MB/sec (3.8GB/min average)
. . .
00:24:41, 155860992 sectors, 32.8MB/sec (3.2GB/min average)
Adjusted sector transfer count on drive 3 to 0x000052b0
Wipe operation on drive 3 is complete!
Target drive 3 is DONE [0x0000], [0x0004]
00:24:47, 156301488 sectors, 44.9MB/sec (3.2GB/min
average)
Operation Complete (00:24:47, 80.0GB)
7.5 Remove HPA Procedure
When using the serial interface, the command syntax for removing a HPA from
each of the target drives is given below:
HPA
=> HPA
Remove Target HPA
OK (y/n)? y
Removing HPA from Target drive 1
Removing HPA from Target drive 2
Removing HPA from Target drive 3
Removing HPA from Target drive 4
Removing HPA from Target drive 5
Removing HPA from Target drive 6
Removing HPA from Target drive 7
Removing HPA from Target drive 8
Operation Complete
20
To Next Page
Loading...