WWW.VORONDESIGN.COM
CAD version: ERCF V2
6161
FILAMENT BLOCKS
6x3mm Magnet
MAGNET ORIENTATION
Polarity matters. Install the magnets in the
middle recess so they repel against the
magnets in the Base, e.g. same poles facing
each other on both magnets.
It’s recommended that you assemble all of the
Filament_Path and Base parts at the same
time to ensure all of the magnet polarities
match.
6x3 Magnet thickness can vary. In case your
magnets are a little loose, add a drop of CA
glue to hold them in place but usually isn’t
required.
Repeat for all of the Filament_Paths.
ECAS-M4 Adapter
Filament_Path_xN
Tag_plates_N
TAG PLATES
Don’t forget to number your
Filament_Paths and Bases, starting
with 0!
FILAMENT PATH
To Next Page
Loading...
