V
X
-
100 User Manual(v01
)
23
4.3 Operation procedure
Always use the device with the cone attached. The cone is fixed to the main unit.
1) If the Jog dial is pressed while the Control Panel is activated, the beep sounds once and the
currently set tube voltage and exposure time is displayed. See the below [Figure 1].
[Figure 1]
2) Turn the jog dial to determine the exposure time[Figure 2]. And Turn the jog dial to determine the
tube voltage. [Figure 3].
When you adjust the exposure time with jog dial, the time on the
control panel is blinked. After setting the desirable exposure time, press the jog dial once to
irradiate X-ray with the desired exposure time. Completely set exposure time is not blinked
on the control panel.
[Figure 2]
[Figure 2]
To Next Page
Loading...