7.4 Manually Add
Click "Manually add", please enter the 15 digits UID that
can be find on the label stick to the floodlight camera's body.
Or you could scan the QR code on the label, the UID will be
filled in automatically, then enter the initial password:
888888, click "Add it".
8.Settings
In the home page of the APP，click the on the top right
corner, go to "Parameter Settings", you will get the following
menus:
Click the icon to switch the page:
You can see the camera's basic Camera Setting:
information,modify the name of the floodlight camera, set up
wireless connection, modify password, upgrade firmware,
adjust the brightness of the LED light, adjust the volume of
the camera and turn on the light sensor mode.
White light brightness: Adjust the value of the brightness of
the LED light
Photosensitive mode: If photosensitive mode is enabled, the
floodlight camera will record the video when human body is
detected and the LED lights will be automatically turned on
when weak light detected.
set up night vision mode, horizontal and Video Viewing:
vertical mirror view,adjust light mode, brightness and
contrast.
check micro SD card capacity, Micro SD Card Recording:
set schedule recording, motion detection recording and
select recording sound or not(suggest you to format the micro
SD card before recording to micro SD card).
turn on/off the motion detection alarm, turn on/off Alarm:
flash light and siren, set up the alarm notification type, and
alarm time frame. The sensitivity of motion detection alarm
was graded into three levels "low/middle/high".
To Next Page
Loading...
