FC2 STATEMENT :
This device complies with Part 15 of the FC2 Rules.
Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may
cause undesired operation.
Warning: Changes or modifications not expressly
approved by the party responsible for
compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B
digital device, pursuant to Part 15 of the FC2 Rules. These
limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This
equipment generates uses and can radiate radio
frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or
television reception, which can be determined by turning
the equipment off and on, the
user is encouraged to try to correct the interference by one
or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit different
To Next Page
Loading...
