124
TEMPORARILY TURNING Off THE MEssAGE
ALERT TONE
If the message alert tone is turned on, the telephone
base beeps every ten seconds when there are new
messages. Pressing any telephone base key temporarily
silences the message alert tone.
If you press X/DELETE when in idle mode to temporarily
turn off the message alert tone, there is a voice prompt
directing you to press X/DELETE again to delete all old
messages. The message alert tone is temporarily off.
Only press X/DELETE a second time if you wish to erase
all old messages in your answering system.
The message alert tone resumes when you receive
another message.
REMOTE ACCEss
A two-digit security code is required to access the
answering system remotely from any touch-tone
telephone. The preset code is 19. See Remote access
code section to change it.
Dial your telephone number from any touch-tone
telephone.
When the answering system answers, press * and
then enter the two-digit remote access code.
Then you can enter one of the following remote
commands.
1.
2.
3.
To Next Page
Loading...
Need help?
General
