VTech AM18447 - Page 4

Introduction
System Overview
Scenario 1
4-single-line connection, with four CM18245/AM18247 desksets and five
CM18045/AM18047 handsets
Your CM18445/AM18447 console is placed in the reception. There are only
single-line wall jacks in your workplace. The 4 single-line cords (model RJ11;
purchased separately) are connected to L1, L2, L3, and L4 jacks of the console
and 4 single-line wall jacks.
Your CM18445/AM18447 console is pre-assigned Ext. 0.
In your workplace, there are four CM18245/AM18247 deskets (Ext. 1, 2, 3, and
4) and five CM18045/AM18047 handsets (Ext. 5, 6, 7, 8, and 9) registered to
the console.
You can use any of the ten stations (Ext. 0, and 1-9) to make and receive a
call with any line from LINE 1, LINE 2, LINE 3, or LINE 4, according to your
preference and need.
NOTE: If your workplace is using two-line wall jacks, please refer to Scenario 2. For three-line wall
jacks, you must first split the lines into 3 single-lines to be connected to L1/2, L2, and L3/4 ports
respectively, or a two-line plus a single line to be connected to L1/2 and L3/4 ports respectively.
The following pages illustrate two possible scenarios of how your 4-line
telephone system can be setup in your workplace. The actual setup depends
on the environment and settings in your workplace.