Introduction
System Overview
Scenario 2
2-double-line connection, with three CM18445/AM18447 desksets, two CM18045/
AM18047 handsets, two IS6100 headsets, and two AT&T model TL80133 speakerphones
Your CM18445/AM18447 console is placed in the reception. There are two-
line wall jacks in your workplace. Two of the telephone line cords provided are
connected to L1/2 and L3/4 jacks of the console and 2 two-line wall jacks.
Your CM18445/AM18447 console is pre-assigned Ext. 0.
In your workplace, there are three CM18245/AM18247 Deskets (Ext. 1, 2, and 3), two
CM18045/AM18047 handsets (Ext. 4 and 5), two IS6100 headsets (Ext. 6 and 7), and
two AT&T model TL80133 speakerphone (Ext. 8 and 9) registered to the console.
You can link IS6100 Headset(s) and/or AT&T model TL80133 speakerphone(s)
to any extensions occupied by the console, and any desket and handset.
You can use any of the ten stations (Ext. 0, and 1-9) to make and receive a
call with any line from LINE 1, LINE 2, LINE 3, or LINE 4, according to your
preference and need.
Before you make or receive a call at IS6100 Headsets or AT&T model TL80133
Speakerphone, you will first need to choose a line at the Main Console or a
specific Deskset/Handset, where the Headsets/Speakerphone are linked.
NOTE: If your workplace is using three-line wall jacks, you must first split the lines into 3 single-
lines to be connected to L1/2, L2, and L3/4 ports respectively, or a two-line plus a single line to
be connected to L1/2 and L3/4 ports respectively. Make sure there is no more than total of 4
lines connect to the L1/2, L2, L3/4, and L4 ports; otherwise, the lines cannot function normally.
To Next Page
Loading...
