VTech BM4000-BEAR - Parent Unit Setup

6
Getting started
7
Parent unit battery installation
You can power up the parent unt by connectng t to AC
power or to the rechargeable battery provded. Even f the
parent unt s connected to AC power, we recommend you
also nstall the battery. Ths guarantees contnual operaton n
case of a power outage.
Install the battery as shown below.
Press down on the large tab of the battery compartment
cover and pull t out.
Wth the label THIS SIDE UP facng up, nsert the
small tabs of the battery nto the slots nsde the battery
compartment. Make sure the metallc contact s correctly
orented as shown below. Push the battery nto the battery
compartment untl t clcks securely nto place.
1.
2.
1
2
3