VTech BM4000-BEAR User Manual

2
3
Getting started
Baby unit installation options
The baby unt s ready for tabletop use. Use the provded wall
mount f you want to mount t on a wall. Make sure to test the
recepton and the baby unt poston before completng the wall
mountng nstallaton (see Test your baby monitor on page 21).
Tabletop to wall mount installation - Method 1
Check for recepton strength and camera angle before drllng
the holes.
Place the wall mount bracket on a wall and then use a pencl
to mark the top and the bottom holes as shown. Remove the
wall mount and drll two holes n the wall (7/32” drll bt).
If you drll the holes nto a stud, go to step 3.
1.
2.
-OR-
If you drll the holes nto an object other than a stud, nsert
the wall anchors nto the holes. Tap gently on the ends wth
a hammer untl the wall anchors are flush wth the wall.
2
1
3
2
1
3

VTech BM4000-BEAR Specifications

General

Brand	VTech
Model	BM4000-BEAR
Category	Baby Monitor
Language	English