VTech BM4000-BEAR - Page 45

Using your baby monitor
3 39
Pair and replace extra new baby unit (continued)
To unpair a baby unit:
Make sure you power on the baby unt and the parent unt
before unparng the baby unt.
On the dle parent unt, press MENU.
Press or to choose Pair/Unpair CAM, then press
SELECT to select.
Press or to choose Unpair CAM, then press SELECT
to select.
Press or to choose a desred baby unt, then press
SELECT.
Press on the parent unt when the screen dsplays To
unpair CAM X, press the [ZOOM] key at the Parent
Unit..
Press SELECT when the screen dsplays Then, press
the [MENU/SELECT] key to confirm..
When unparng s successful, the screen dsplays CAM X
is unpaired and returns to prevous menu. If there s no
pared baby unt, the screen dsplays No CAM is paired..
The LED lght on the selected baby unt flashes slowly.
1.
2.
3.
4.
5.
6.
7.