24
Basic Operation
“Set Audible Message Alert ” When Message Alert is turned on, the base beeps
Off * once every 10 seconds when new messages
On have been received.
Set Announce Only When you turn Announce Only On, callers hear
Off * your announcement, but cannot leave a message
On
Set Base Ringer Turn the base ringer on or off.
On *
Off
Set Number of Rings Choose how many times the phone will ring
2 before the system answers a call.
4 * With Toll Saver active, the system answers after two
6 rings when you have new messages and after
Toll Saver four rings when you have no new messages.
NOTE: You can exit Feature Setup at any time by pressing a MAILBOX button.
Setting Up Your Answering System
You can set up one feature at a time, or you can set up a feature and then move
on to set up another feature.
1. Make sure the answering system is on.
2. Press
MENU
until the system announces the feature you want to set. Refer
to the Feature Summary below for a description of the features and your choices.
3. Press
SELECT
until the system announces the desired setting.
4. Press
TIME/SET
to confirm your selection.
5. Press
MENU
to move on to the next feature or press a button to exit
Feature Setup.
Feature Summary
Default settings indicated by * .
System announces: Description/directions:
Set Security Code Use
SELECT
to choose the remote access code
you will use to access features and functions of the
answering system from a touch tone phone. You can
select any 2-digit code, from 40 to 99.
Note: To advance the romote access code by 10,
press and hold SELECT.
System announces: Description/directions:
Answering System Operation At The Base
50*
To Next Page
Loading...
