30
California Energy
Commission battery
charging testing
instructions
This telephone is set up to comply with the
energy-conserving standards right out of
the box. These instructions are intended
for California Energy Commission (CEC)
compliance testing only. When the CEC
battery charging testing mode is activated, all
telephone functions, except battery charging,
will be disabled.
To activate the CEC battery charging
testing mode:
1. Unplug the telephone base power
adapter from the power outlet. Make sure
all handsets are plugged with charged
batteries before proceeding.
2. While you press and hold
FIND HANDSET, plug the telephone
base power adapter back to the power
outlet.
3. After about 20 seconds, when the
IN USE light starts flashing, release
FIND HANDSET and then press it again
within 2 seconds.
• When the phone successfully enters the CEC
battery charging testing mode, the IN USE light
turns off and all handsets display To register
HS... and ...see manual alternatively.
• When the phone fails to enter this mode, repeat
Step 1 through Step 3 above.
To deactivate the CEC battery charging
testing mode:
1. Unplug the telephone base power
adapter from the power outlet, then plug
it back in. Then the telephone base is
powered up as normal.
2. Place the handset in the telephone base
to register it back. The handset displays
Registering....
• The handset shows Registered when the
registration process completes. The registration
process takes about 60 seconds to complete.
The Ringer Equivalence Number (REN)
for this terminal equipment is 1.0. The
REN is an indication of the maximum
number of devices allowed to be
connected to a telephone interface. The
termination on an interface may consist
of any combination of devices subject
only to the requirement that the sum of
the RENs of all the devices does not
exceed five.
This product meets the applicable
Industry Canada technical specifications.
To Next Page
Loading...
Need help?
General
