6
Getting started
Installation options
Your telephone base is ready for tabletop use. If you want to mount yourIf you want to mount your
telephone on a wall, use the provided wall bracket to connect with a standard
dual-stud telephone wall mounting plate. If you do not have this mounting
plate, you can purchase one from many hardware or consumer electronics
retailers. You may need a professional to install the mounting plate.
Tabletop to wall mount installation
If you are using a DSL lter, plug the line cord into the lter now. Plug
the telephone line cord (or DSL lter) into the wall jack. Plug the power
adapter into a power outlet not controlled by a wall switch.
Position the telephone base as shown below. Insert the extended
tabs (marked B) of the wall bracket into the slots on the back of the
telephone base (marked B). Push the telephone base down until it clicks
securely in place.
Route the telephone line cord (or DSL lter) and power cord through the
wall bracket hole and plug them into the bottom of the base.
Align the holes on the bracket with the standard wall plate and slide the
bracket down until it locks securely. Bundle the telephone line cord and
power adapter cord neatly with twist ties.
1.
2.
3.
4.
To Next Page
Loading...
Need help?
General
