VTech DS6322-4 User Manual

15
Bluetooth
Cellular setup
completed
Device
connected
Pair a cell phone (continued)
Enter the PIN of the telephone base (the default
PIN is 0000) into your cell phone to continue the
pairing process.
When a device is successfully connected, the handset
displays Paired with cellular and then Cellular setup
completed Device connected. The corresponding
status icon ( 1 or 2) displays. The corresponding
device light on the telephone base (DEVICE1 or
DEVICE2) turns on.
When you already have two devices on the active
devices list, the handset shows Maximum of 2
devices can be connected. You are prompted to
replace an existing device on the active devices list
(page 21).
If you have trouble pairing your cell phone, it may not be compatible
with your DS6321/6322. Check the Bluetooth compatibility list at
www.vtechphones.com.
Auto connection
When a device is successfully paired with the telephone
base but not connected, the handset displays
Cellular setup completed Device not connected and
then Auto-connect function enabled Press SELECT.
You can press MENU/SELECT to exit. You can connect a
device manually (page 20).
7.
8.
•
The pairing process may take up to one minute. If the pairing process fails,
try again.
The steps for the pairing process may vary for different cell phones. If this
happens, follow the prompts on your cell phone and your DS6321/6322 to
complete the pairing process
If you put the handset back in the telephone base or charger while pairing,
the process discontinues and the handset returns to idle mode.
•
•
•
Cellular setup
completed
Device not
connected
Auto-connect
function
enabled
Press SELECT
Base name:
VTech DS6321
PIN:0000

VTech DS6322-4 Specifications

General

Brand	VTech
Model	DS6322-4
Category	Cordless Telephone
Language	English