35
Answering system settings
Announcement
The telephone is preset with a greeting that answers calls with
“Hello, please
leave a message after the tone.”
You can use this preset announcement, or
replace it with your own.
Play your announcement
Press MENU/SELECT on the handset when it is not
in use.
Press MENU/SELECT to choose Ans. system.
Press or to highlight Announcement, then press
MENU/SELECT.
The handset announces,
“To play, press 2. To record,
press 7.”
Press 2 to play.
Record your own announcement
Press MENU/SELECT on the handset when it is not
in use.
Press MENU/SELECT to choose Ans. system.
Press or to highlight Announcement, then press
MENU/SELECT.
The handset announces,
“To play, press 2. To record,
press 7.”
Press 7 to record.
The handset announces, “Record after the tone. Press
5 when you are done.” After the tone, speak towards
the microphone of the handset.
Press 5 when you nish recording.
The handset automatically plays back the newly
recorded announcement. Press 5 to stop the playback
at any time; 2 to replay the recorded announcement; or
7 to record again if desired.
1.
2.
3.
4.
1.
2.
3.
4.
5.
6.
7.
Your announcement can be up to 90 seconds in length.
Announcements shorter than two seconds will not be recorded.
•
•
ANNOUNCEMENT
2-Play
3-Delete
5-Stop
7-Record
ANS. SYSTEM
Play messages
Announcement
Delete all old
Record memo
Recording
announcement...
5-Stop
Announcement
playback
To Next Page
Loading...
Need help?
General
