3
Getting started
Telephone base and charger installation
Install the telephone base and charger(s) as shown below.
Make sure that the electrical outlet is not controlled by a wall switch.
If you subscribe to digital subscriber line (DSL) high-speed Internet service
through your telephone line, you must install a DSL lter between the
telephone line cord and the telephone wall jack. The lter prevents noise and
caller ID problems caused by DSL interference. Contact your DSL service
provider for more information about DSL lters.
Use only the power adapters supplied with this product. To order a
replacement, visit our website at www.vtechcanada.com
or call 1 (800) 267-7377.
The power adapters are intended to be correctly oriented in a vertical or
oor mount position. The prongs are not designed to hold the plug in place if
it is plugged into a ceiling, under-the-table or cabinet outlet.
•
•
Telephone line cord
DSL filter (not
included) is required
if you have DSL
high speed Internet
service
Telephone
base power
adapter
Electrical outlet
not controlled
by a wall switch
Telephone wall jack
Telephone base
Power
adapter
Charger
To Next Page
Loading...
Need help?
General
