28
Wireless mic registration
Your wireless mics are pre-registered. If for some reason, you want to
purchase replacement wireless mics (VCS702-WM), visit our website at
http://businessphones.vtech.com or call 1-800-595-9511. In Canada, call
1-800-267-7377. You should register your new wireless mics to the base unit following
the instructions below.
To register a wireless mic
As part of this process, all existing, broken, or lost wireless mics will be deregistered
first. Then, the base unit will re-register the two wireless mics that are placed onto the
charging cradles.
Before registration, unplug the telephone line cord from the wall jack to make sure
there are no incoming calls during registration.
Gather the two wireless mics that are to be registered and place them onto the
charging cradles.
Enter 331734 on the base unit when it is not in use, and then press .
The screen displays Please place all wireless mics on cradle, then
press ‘SELECT’.
Make sure both wireless mics are on the charging cradles, and then press
. The wireless mics enter the deregistration mode, and the screen displays
Processing....
After deregistration is complete, registration starts. The screen displays
Registering... 1 2. The number X blinks while registering the X-th wireless mic. You
hear a confirmation tone when each wireless mic is registered. When both wireless
mics are registered, the base unit displays Registration done.
After registration, plug the telephone line cord back into the wall jack.
If registration has failed, the base unit will display Registration failed. Try again and returns
to idle. You hear an error tone. Remove the wireless mics from the charging cradles and place
them back in. Repeat steps 1 to 3 to try the entire registration process again.
If the screen does not display Registration done after step 3, repeat steps 1 to 3 to try the
entire registration process again.
All wireless mics should always be kept on the charging cradles during the whole registration
process. Any wireless mic that is registered before but not put onto the charging cradle will be
deregistered after the above operations.
Status indicators on the wireless mics flash red and green alternately during registration.
To cancel registration, press . The base unit displays Registration cancelled. If
registration is cancelled, some of the wireless mics may be deregistered. To register them back
to the base unit, repeat steps 1 to 3 to try the entire registration process again.
1.
2.
3.
•
•
•
•
•
To Next Page
Loading...
Need help?
General
