VTech IS8251-3 User Manual

Industry Canada
This device contains licence-exempt
transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic
Development Canada’s licence-exempt
RSS(s).
Operation is subject to the following two
conditions:
(1) this device may not cause interference,
and (2) this device must accept any
interference, including interference that
may cause undesired operation. Privacy of
communications may not be ensured when
using this telephone.
The term ‘’IC:‘’ before the certification/
registration number only signifies that the
Industry Canada technical specifications
were met.
The Ringer Equivalence Number (REN) for
this terminal equipment is 1.0. The REN
is an indication of the maximum number
of devices allowed to be connected to a
telephone interface. The termination on an
interface may consist of any combination of
devices subject only to the requirement that
the sum of the RENs of all the devices does
not exceed five.
This product meets the applicable Innovation,
Science and Economic Development
Canada technical specifications.
California Energy Commission Battery
charging testing instructions
This telephone is set up to comply with the
energy-conserving standards right out of
the box. These instructions are intended
for California Energy Commission (CEC)
compliance testing only. When the CEC
battery charging testing mode is activated,
all telephone functions, except battery
charging, will be disabled.
To activate the CEC battery charging testing
mode:
1. Unplug the telephone base power
adapter from the power outlet. Make
sure all handsets are plugged with
charged batteries before proceeding.
2. While you press and hold FIND HS, plug
the telephone base power adapter back
to the power outlet.
3. After about 20 seconds, when the
HOME light starts flashing, release
FIND HS and then press it again within
two seconds. You hear a confirmation
tone. The HOME light turns on and all
handsets display To register HS... see
manual alternately. Allow up to one
minute for the process to complete.
If the phone fails to enter this mode,
repeat all the steps mentioned above. The
telephone base will be powered up as
normal if you fail to press FIND HS within
two seconds in Step 3.
To deactivate the CEC battery charging
testing mode:
1. Unplug the telephone base power
adapter from the power outlet, and then
plug it back in. Then the telephone base
is powered up as normal.
2. Put the handsets on the telephone base
cradle to begin registration.
3. The handset shows Registering... If the
registration is successful, the handset
screen displays Registered and beeps.
The handset is registered with the
telephone base.

VTech IS8251-3 Specifications

General

Brand	VTech
Model	IS8251-3
Category	IP Phone
Language	English