CONNECTING TO A COMPUTER
You can connect KidiZoom
®
Camera Pix
TM
Plus to a PC or Mac
computer by using a micro USB cable (not included). Once connected,
you can transfer les between the camera and computer following
these steps:
• Turn the camera Off before connecting to a computer.
• Pull up the rubber cover of the USB port at the bottom of your camera.
• Insert the small end of the USB cable (not included) into the USB port
on the camera.
• Insert the larger end of the USB cable (not included) into a USB port on
your computer. A USB port is usually marked with this symbol
.
• Two removable drives called VTech 5489 and VT SYSTEM will
appear. VTech 5489 is for storage of your data, VT SYSTEM is for
storage of system data and cannot be accessed.
Note: If there is a memory card in the camera, the removable drive will
show the contents of the memory card only.
To avoid any potential damage to your KidiZoom
®
Camera Pix
TM
Plus:
• When the USB cable (not included) is not connected to the camera,
ensure the USB rubber cover is fully covering the USB port of the
camera.
• Please ensure the microSD card slot rubber cover of the camera is
tted in place.
Note:
Once the camera is connected to your computer, do not insert or remove
the memory card and do not disconnect the camera while les are
transferring. After you nish, remove the camera by taking the appropriate
steps for your system to safely remove hardware from your computer.
You can then physically unplug the camera from the computer.
To Next Page
Loading...
