7
• Insert the large end of the Micro-USB Cable into a USB port on your
computer.
• Once the connection is successful, you will see a battery recharging
symbol appear on the watch screen.
• Check the charging progress regularly throughout recharging.
• When the battery is fully charged, a tick icon will appear on the
battery icon. Then the screen will automatically turn off. You may then
disconnect your fully charged watch from the computer.
Note: It takes approximately 3 and a half hours to fully charge the battery.
The actual charging time depends on the charging current, the remaining
charge in the battery prior to recharging, and the ambient temperature.
The optimum ambient temperature is 32°F - 104°F (0°C - 40°C).
CHARGING GUIDELINES
Only charge this device using the included Micro-USB Cable connected
to a computer. Do not charge using a third party adaptor. Before use,
inspect the cord to conrm that it is in good condition and that there are
no breaks or exposed wires. Ensure there are no particles or liquid (water,
juice, etc.) in either of the connectors before plugging in either end of the
cable. The device should be completely dry with no debris in the cable
connectors when charging. Plug in the cable securely, in the correct
orientation. If the device is on when plugged in, a dialogue box may pop
up on your computer to allow you to access the device's drive. Never
leave the device unattended while charging. Do not charge your device on
soft surfaces, as they can trap heat around the device. Typical charging
time is approximately 3 and a half hours if the battery is fully depleted.
Disconnect the device when it is fully charged. Do not leave the device
charging for more than 5 hours.
This device does not support wireless charging. Do not put it on a wireless
charger.
To Next Page
Loading...
Need help?
General