www.vtechphones.com
31
Additional information
Problem Suggestion
Common cures for elec-
tronic equipment.
If the base unit does not seem to be responding normally, try putting the handset in the base unit. If itbase unit. If it. If it
still does not respond, do the following (in the order listed):
1. Disconnect the power to the base unit.base unit..
2. Disconnect the handset battery, and spare battery, if applicable.
3. Wait for a few minutes.
4. Connect power to the base unit.base unit..
5. Re-install the battery.
6. Wait for the handset to synchronize with the base unit. To be safe, allow up to one minute for thisbase unit. To be safe, allow up to one minute for this. To be safe, allow up to one minute for this
to take place.
Troubleshooting
To single telephone jack
(RJ11C)
Telephone line cord
(For DSL users)
If you subscribe to DSL service:
If you hear noise during conversations and/or your caller
ID features are not functioning properly, install a noise
the telephone line jack. Contact your DSL provider to
To Next Page
Loading...
Need help?
General
