11
Using the V.Reader
TM
Touch Screen
V.Reader
TM
has a touch-sensitive screen that you can interact with by using your
nger or the included pen. Lightly touch the screen with your nger or the pen.
NOTE:
• Use only enough pressure to operate the game. Too much pressure may
damage the touch screen.
• Do not use the pen if it is broken.
• Do not use any other pens on the touch screen other than the V.Reader
TM
pen.
• Put the pen back in the pen holder when not in use.
Cleaning the V.Reader
TM
Touch Screen
If the screen on your V.Reader
TM
has visible smudges, ngerprints or other material
on it, you can clean it with the included soft cloth.
1. Slightly dampen the cloth with an alcohol-based cleaner and wipe the screen
to loosen dirt.
2. Using a clean, dry cloth, wipe the screen dry. Repeat these two steps as
needed.
Inserting an SD CardInserting an SD Card
You can insert an SD card (not included) into your V.Reader
TM
, to store downloaded
content.
•
Make sure the unit is turned off.
•
Open the battery cover, as shown in image 4.
• Make sure the batteries have been removed.
• Locate the SD card slot inside the battery cover.
• Insert the SD card as shown in image 5.
• Make sure to replace the battery cover.
GAME
HIGHLIGHT
MUSIC OFFMENU
GAME
HIGHLIGHT
MUSIC OFFMENU
or
To Next Page
Loading...
Need help?
General