23
Registering the handset to the base station
The handset must be registered to the base station in order to make and receive
calls.
To register the handset:
1. Make sure the handset has a charged battery before proceeding.
Make sure the base station is connected to power.
2. If the handset is displaying the following message, go to step 7.
Otherwise, go to step 3.
Press and hold
HANDSET LOCATOR
key at base for
4 seconds
3. Press MENU on the handset. The Main Menu appears.
4. Press q to scroll to User settings and press SELECT.
5. Press q to scroll to Registration and press SELECT.
6. With This Handset highlighted, press SELECT.
The handset screen displays instructions.
7. On the base station, press the HANDSET LOCATOR button for at least four
seconds, then release the button. Both LEDs on the base station begin to
ash.
8. Press the # key on the handset to begin registration.
The screen displays Registering Please wait.
The process takes up to 10 seconds to complete. When registration is
complete, the handset beeps and displays Handset Registered.
If the handset fails to register, place it in the charger again for a few seconds,
remove it and repeat the registration procedure.
Then, press the
#key at the
Handset.
To Next Page
Loading...
Need help?
General
