Vympel CONG Prima 2M - Page 13

!
4"!
«param. view»
In the “param. view” function, the current operational parameters of the CP 2M can be
checked and adjusted.
This sub-point has four configuration options for operating parameter groups that directly
affect the accuracy of the measurement process and the information displayed. The
operating parameter groups are selected by touching the «▲» and «▼» buttons with the
magnetic key, and activated by touching the «►» button.
Touch the «◄» button to return to the main menu.
The parameters are subdivided into the following function groups:
«GENERAL PARAM.»
Parameter group for the algorithm that defines the general
operation of the CP 2M;
«W CYCLE PARAM.»
(Water cycle)
Parameter group for the algorithm that defines the
measurement of the dew point of water (dpW);
«НС CYCLE PARAM.»
(Hydrocarbon cycle)
Parameter group for the algorithm that defines the
measurement of the dew point of hydrocarbons (dpHC);
«LINK PARAM»
(Parameter transfer)
Parameter group that defines the transfer of data via
ModBus/RTU protocol;
Warning!
Each modification of the CP 2M parameters can permanently
compromise the analyzer’s performance.