!
The following parameters are preset:
- data transmission rate = 38,400
- corresponds to the address of the device – 100
(In networks with multiple devices, the analyzer’s address can be set at a value of 1 to 247.)
A complete list of all the factory default settings for the various parameters of the CP 2M can
be found in Appendix E.
Use the «▲» or «▼» button to select a specific parameter within a particular sub-menu.
Confirm the selection by touching the «►» button.
Changes in parameter values can be made using the following control commands:
open/ close a menu for making adjustments to parameters
(a blinking “x” appears in the display)
Change the type of parameter (move the cursor)
Change the parameter value
Confirm the new value (the cursor “x” doesn’t blink)
Return to the menu point one step higher in the hierarchy
Please note:
A password is required to access the menu point for changing parameter settings.
The window in which to enter the password appears in the display when a change to a
parameter value is entered. The password access window also appears when the service
menu is opened.
In addition, the password is required when the CP 2M started or restarted.
To Next Page
Loading...