!
6 Markings
The markings on the analyzer’s housing provide information about:
" Trademark and name o the manufacturer
" Description of the device
" Ignition protection markings
" Certifying authority and certificate number
" Markings about the type of protection against solid contaminants and water in
accordance with IEC 60529:1992(IP54)
" Dew point measurement range
" Operating pressure tolerance
" Operating temperature of the device
" Serial number
" Country of origin
7 Packing
The component parts of the analyzer must be properly conserved before they are packed for
shipping or storage.
The device is to be packed in a closed, well-ventilated rooms with an ambient temperature of
+15 °C – +40 °C and with a relative humidity of up to 80%.
The ambient air must not contain any aggressive constituents.
The packaging protects the device against climatic influences and mechanical stresses
during loading and unloading, transport, and storage.
The operating documents are located under the cover in the upper half of the transport case.
The devices accompanying documentation are in watertight packaging and are also found in
the compartment in the transport case cover.
8 Storage
Analyzers are only to be stored in the containers designated for that purpose by the
manufacturer. These containers protect the instruments from mechanical damage,
contamination, and the effects of aggressive media.
For transport purposes, analyzers may be temporarily stored for up to six months in the
purpose-built transport packaging.
To Next Page
Loading...