10 Appendix III
109
WABCO Maintenance Manual MM-0112 (Revised 07-18)
Figure 10.8
The ESC EOL Initialization procedure is completed. Click the “Close”
button to close the screen.
NOTE: If ESC EOL initialization was not properly completed and/or
ratios correctly saved, code SPN 520210 88 FMI 14 will be active.
Follow the ESC initialization again and make sure each portion is
successfully completed. Make sure ignition power down is
completed for the ECU to successfully save data.
Figure 10.8
To Next Page
Loading...
