Wacker Neuson AR - Maintenance; Safety; Maintenance Personnel Qualifications; Maintenance Schedule

11 Maintenance
100_0102_mt_0003.fm 28
11 Maintenance
11.1 Safety
The following instructions must be complied with:
 This machine must not be serviced, repaired, set or cleaned while it is switched on.
 Observe maintenance intervals.
 Safety devices must be reattached to the machine after each maintenance or repair. Missing safety
devices can lead to serious injuries and cause total failure of the machine.
 Observe maintenance schedule. Missed maintenance work can lead to machine damage.
 Always replace worn or damaged parts immediately. Only use spare parts from Wacker Neuson.
 Keep the machine clean.
 Missing, damaged or illegible safety stickers must be replaced immediately. Safety stickers contain
important information to protect the operator.
 Maintenance work must be performed in a clean and dry environment (e.g. workshop).
11.2 Maintenance personnel qualifications
Maintenance work described in this manual may be performed by any trained operator unless otherwise
indicated.
Some maintenance work may only be performed by specially trained personnel or by the service staff of
your Wacker Neuson contact - these are specifically noted.
11.3 Maintenance schedule
WARNING
Improper handling can lead to serious injuries or material damage.
 Read and observe all safety information in this manual.
WARNING
Improper handling may cause a danger to life by electrocution.
 Only a qualified electrician is permitted to open the machine, perform repairs, and
perform a subsequent safety check in accordance with applicable regulations.
 Remove the plug from the plug receptacle before all work on the machine.
Task Daily Every 20 h Every 150 h
Visual inspection of all parts for damage. 
Check that power cable is in perfect condition – replace defective
power cables immediately.*

Check the tightness of all screws on the machine and fastening
screws.

Lubricate machine (cylindrical roller bearings). 
Clean the machine. 
Check the Bodyguard® for damages. 
Function testing the Bodyguard® with the test button. 
*
Must be performed by a Wacker Neuson representative.