12 Troubleshooting
31 100_0102_ts_0003.fm
12.4 Inverter
Malfunction Cause Remedy
Control lamp lights red.
Line voltage is interrupted.
Incorrect line voltage.
Inverter starts automatically as
soon as the correct line voltage is
available (again).
Control lamp flashes red. Defect in the vibrator head. Have the machine repaired.*
Control lamp flashes red twice. Inverter has switched off due to
excess temperature.
1. Allow the inverter to cool down.
2. Carry out a reset:
Switch the machine off and on
again.
Control lamp flashes red three
times (for a short period).
The Bodyguard
®
has turned off the
machine.
1. Pull out the plug.
2. Eliminate the fault or have it
eliminated. *
3. Insert the plug.
No Bodyguard
®
present. Have the machine reset to its
original condition. *
*
Have these tasks carried out by the service department of your Wacker Neusoncontact person.
To Next Page
Loading...
