What to do if my Wacker Neuson Power Tool is losing hydraulic oil?
If you notice a loss of hydraulic oil in your Wacker Neuson Power Tool, it's likely due to leaks. In this case, have the machine repaired.
What to do if my Wacker Neuson Power Tool is not moving forward?
If your Wacker Neuson Power Tool isn't moving forward, it indicates a mechanical fault. Have the machine repaired.
What to do if reverse travel speed is too low on my Wacker Neuson Power Tool?
If the reverse travel speed on your Wacker Neuson Power Tool is too low, it's likely due to insufficient hydraulic oil in the centre pole head. Fill it with hydraulic oil.
What to do if compaction display LEDs are flashing on Wacker Neuson Power Tool?
If all the LEDs on the compaction display of your Wacker Neuson Power Tool are permanently flashing after initialisation, the sensor has not been successfully tested. This could be due to the switch-on procedure occurring when the engine is running, which requires professional repair.
Explains safety symbols (DANGER, WARNING, CAUTION, NOTE).
Covers safety for working area, service, personal safety, and handling/use.
Safety for external influences, operational procedures, and safety distances.
Details required PPE like safety shoes, gloves, and ear protection.
Explains the function of various controls and displays on the machine.
Pre-operation checks and adjusting the centre pole.
Procedures for starting the machine: manual, cold manual, and electric start.
How to operate the machine, including travel direction and compaction display.
Lists scheduled maintenance tasks and their frequencies.
Detailed instructions for specific maintenance tasks.
Lists common faults, their causes, and remedial measures.
Step-by-step guide for jump-starting the machine with a donor battery.
General| Engine Type | Diesel |
|---|---|
| Engine Manufacturer | Hatz |
| Frequency | 69 Hz |
| Base Plate Length | 554 mm |
| Travel Speed | 24 m/min |
| Fuel Tank Capacity | 5.5 L |
To Next Page