Wacker Neuson VP - Page 36

Maintenance
9.3 Maintenance work
36
Operator’s manual | VP | 5100056064 | 02/2020 | [en]
2
4. Unscrew the engine oil drain plug with sealing ring 2.
5. Allow the used oil to drain completely.
6. Tighten the engine oil drain plug with new sealing ring, tightening
torque 18 Nm.
7. Place the machine in a horizontal position.
8. Fill in new engine oil, see Checking and topping up engine oil level
on page 35 .
9. Tighten the engine oil dipstick again.
9.3.6 Cleaning the deposit cup
3
B
1. Move the fuel cock3 into positionB.
2
2. Remove deposit cup, filter and O-ring 2.
3. Clean and dry deposit cup and filter.
4. Replace the O-ring, filter and sedimentation cup.