5.5
Changing the Engine Oil
Procedure Perform th procedure below to change the engine oil.
1.
Drain the oil while the engine is still warm.
2.
Remove the oil filter plug (a) and the drain plug (b) to drain the oil.
Note: In the interest of environmental protection, place a plastic sheet and a
container under the machine to collect any liquid that drains off. Dispose of this
liquid in accordance with environmental protection legislation.
3.
Install the drain plug.
4.
Fill the engine crankcase with the recommended oil up to the level of the lug
opening (c). See chapter Technical Data for oil quantity and type.
5.
Install the oil filler plug.
wc_gr000087
5.6
Cleaning the Sediment Cup
Procedure Perform the procedure below in cleaning the sediment cup.
1.
Turn the fuel valve off.
2.
Remove the sediment cup (a) and the O-ring (b).
3.
Wash both thoroughly in a non-flammable solvent. Dry and re-install them.
4.
Turn the fuel valve on and check or leaks.
wc_gr000029
To Next Page