5
safety precautions
PS 3.25
• All accessories must be rated at or above
the maximum operating pressure range of
the sprayer. This includes spray tips, guns,
extensions, and hose.
HAZARD: HIGH PRESSURE
HOSE
The paint hose can develop leaks from
wear, kinking and abuse. A leak can
inject material into the skin. Inspect
the hose before each use.
PREVENTION:
• Avoid sharp bending or kinking of the high-
pressure hose. The smallest bending radius
amounts to about 20 cm.
• Do not drive over the high-pressure hose.
Protect against sharp objects and edges.
• Replace any damaged high-pressure hose
immediately.
• Never repair defective high-pressure hoses
yourself!
• Electrostatic charging of spray guns and the
high-pressure hose is discharged through
the high-pressure hose. For this reason the
electric resistance between the connections
of the high-pressure hose must be equal to or
lower than 1MΩ.
• For reasons of function, safety and durability
use only original Wagner high-pressure
hoses.
• Before each use, check all hoses for cuts,
leaks, abrasion or bulging of cover. Check
for damage or movement of couplings.
Immediately replace the hose if any of
these conditions exist. Never repair a paint
hose. Replace it with another earthed high-
pressure hose.
• Make sure power cord, air hose and spray
hoses are routed in such a manner to minimize
slip, trip and fall hazard.
To Next Page
Loading...
Need help?
General
